Cookies help us to provide our services. By using our services, you agree to our use of cookies. For more information about cookies, please follow the link below. What are cookies?Cookie settings
Accept all cookies
Cookies to ensure operational readiness cannot be disabled insofar as we use them to provide our services. We use cookies to provide our services, for example, to: recognize when you sign in to use our services; store information you have added to your watch list; prevent fraudulent activity; improve security.
Statistical cookies help us provide you with an optimal user experience by collecting anonymized statistical data from visitors. This data is collected by us and our partners.
Accept all cookies
Save selection
MV 240 digital - the revolutionary all-in-one measuring solution
2019-03-05 03:51:07, Microtech Gefell GmbH
The 1/2“ measurement microphone pre-amplifier type MV 240 digital combines a high-impedance transducer with an analog-to-digital converter. The output signal of the measurement microphone capsule is optimally adjusted to the dynamic range of the analog-to-digital converter by an impedance converter and a pre-amplifier with a very low noise level and THD. One channel of a 24 bit analog-to-digital converter converts the lower level range of the capsule signal and the other channel the upper level range. A following processor combines these two level ranges to the one-channel 32 bit output signal, that represents calibrated sound pressure levels. The MV 240 digital converts sound pressure levels from 7 dB to 160 dB – more than the complete dynamic range of a typical 1/2“ measurement microphone capsule. The pre-amplifier supports the sample frequencies 48 kHz, 96 kHz and 192 kHz. Measurements up to 80 kHz are possible with 1/4“ measurement microphone capsules. For the use of the MV 240 digital no special hardware driver is necessary because it is detected automatically by the operating system and can be used with Windows, MacOS and Linux. The MV 240 digital is powered by the USB interface and generates internally 200 V polarisation voltage for the measurement microphone capsule that can be switched off when using electret measurement microphone capsules. The pre-amplifier is connected to the USB interface via a lockable LEMO® connector and a special LEMO® to USB adapter cable. Two integrated generators can be used to check the 32 bit processing of the following signal chain and to detect the reference value for a sound pressure of 1 Pascal. Disadvantages of earlier AD solutions could be overcome, e.g. - cumbersome installation / operation, - errors due to complicated coordination of several electronic/software components, - handling the voltage as a coupler, - acoustic USB artifacts, - insufficient sensitivity, limited frequency range, etc.